+高级检索
Ti-1300合金锻造加工的热压缩模拟
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家“973”项目(2007CB613805)


Forging Simulation of Ti-1300 Alloy by Hot Compressing Testing
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用Gleeble-1500热模拟机对Ti-1300近β钛合金进行热压缩变形,研究其在温度为800~1010 ℃、应变速率为0.01~10 s-1、最大变形量为60%条件下的热变形行为。对热变形后的组织进行分析可知,在低应变速率下,主要发生动态再结晶;在高应变速率下,主要发生动态回复。根据试验数据得出了该合金的加工图,结果表明,Ti-1300合金在高应变速率下变形容易发生流变失稳现象,因此其锻造工艺应宜在较低的变形速率下进行,可得较细小的等轴动态再结晶组织

    Abstract:

    With Gleeble-1500 heat simulator performing heat compressive deformation on Ti-1300 near β alloy, its heat deformation behavior is researched with the temperature range of 800~1010 ℃, strain rate of 0.01~10 s-1 and maximum deformation of 60%. The structure analysis after heat deformation indicates that re-crystallization primarily occurs under the condition of low rate of strain, but dynamic recovery under the condition of high rate of strain. According to the test data, the manufacturing drawing of this alloy is obtained. The result indicates that for Ti-1300 alloy, rheological phenomenon easily occurs under the condition of high rate of strain which leads its unstableness. Therefore, its forging procedure should be performed under relative low rate of strain, thus relative fine structure of equal axial dynamic re-crystal could be obtained

    参考文献
    相似文献
    引证文献
引用本文

赵映辉,葛 鹏,杨冠军,赵永庆,毛小南. Ti-1300合金锻造加工的热压缩模拟[J].稀有金属材料与工程,2009,38(3):550~553.[Zhao Yinghui, Ge Peng, Yang Guanjun, Zhao Yongqing, Mao Xiaonan. Forging Simulation of Ti-1300 Alloy by Hot Compressing Testing[J]. Rare Metal Materials and Engineering,2009,38(3):550~553.]
DOI:[doi]

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2008-03-31
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期:
  • 出版日期: