+高级检索
热处理工艺对Ti-1300合金的组织和拉伸性能的影响
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家“973”项目(2007CB613805)


Effect of Heat Treatment Process on Microstructure and Tensile Properties of Ti-1300 Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    研究了Ti-1300合金经不同温度固溶+缓慢升温时效处理后的显微组织和拉伸性能。结果表明,在相变点之上和之下固溶+随炉升温时效处理后合金发生了不同的相变,对应的拉伸性能也有很大的不同。Ti-1300合金在相变点之上固溶处理后缓慢升温到500 ℃时效处理发生β→ω转变,试样强度很高,而塑性很差。Ti-1300合金在相变点之下固溶处理+随炉升温时效处理发生β→α转变,试样经随炉升温到570 ℃时效处理后的抗拉强度为1430 MPa,而延伸率也达到8%。

    Abstract:

    The microstructures and tensile properties of Ti-1300 alloy after solid-solution treatment at different temperatures followed by slow heating aging were studied. The results indicate that the different phase transformations of the alloy took place after the solid-solution/aging treatment at up-and-down phase transformation temperature (PTT), and the corresponding tensile properties of the alloy also showed obvious difference. β→ω transformation occurred when the samples were solid-solution treated at the upper PTT and then aged heating slowly to 500 ℃. After this treatment, the alloy had high strength but low plasticity. On the contrary, when the samples were solid-solution treated at the down PTT followed by furnace heating ageing, β→α transformation occurred and the tensile strength of the alloy was 1430 MPa and elongation was 8.0% after aging heating up to 570 ℃.

    参考文献
    相似文献
    引证文献
引用本文

汶建宏,葛 鹏,杨冠军,毛小南,周 伟.热处理工艺对Ti-1300合金的组织和拉伸性能的影响[J].稀有金属材料与工程,2009,38(8):1490~1494.[Wen Jianhong, Ge Peng, Yang Guanjun, Mao Xiaonan, Zhou Wei. Effect of Heat Treatment Process on Microstructure and Tensile Properties of Ti-1300 Alloy[J]. Rare Metal Materials and Engineering,2009,38(8):1490~1494.]
DOI:[doi]

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2008-07-31
  • 最后修改日期:2009-06-24
  • 录用日期:
  • 在线发布日期:
  • 出版日期: