+Advanced Search
Sintering Properties and Microstructure of Fe-Ni-Co-based Superalloy Atomized Alloy Powder
DOI:
Author:
Affiliation:

State Key Laboratory for mechanical behavior of materials , Xi’an Jiaotong University,State Key Laboratory for mechanical behavior of materials , Xi’an Jiaotong University,Xi’an Thermal Power Research Institute Co., LTD,State Key Laboratory for mechanical behavior of materials , Xi’an Jiaotong University,DongFang Turbine Co., LTD,DongFang Turbine Co., LTD

Clc Number:

Fund Project:

  • Article
  • |
  • Figures
  • |
  • Metrics
  • |
  • Reference
  • |
  • Related
  • |
  • Cited by
  • |
  • Materials
  • |
  • Comments
    Abstract:

    Fe18Ni23Co25Cr21Mo8WNb3C2 superalloy powders were synthesized via atomization method, and phase composition, morphology and thermal stability of composite powders were respectively characterized. Based on the above analysis, atomized alloy powders were fabricated by vacuum hot-pressed sintering and further second sintering. The sintering Fe-Ni-Co-based superalloy mainly consists of austenite phase and M6C carbide phase, which was a strengthening phase. Experiment results indicate that superalloy have uniform structure, high tensile strength and low elongation after vacuum hot-pressed sintering. Further second sintering, microstructure of superalloy become more homogeneous, the tensile strength decreases slightly and the elongation rate significantly increases.

    Reference
    Related
    Cited by
Get Citation

[sunchongfeng, dangxiaofeng, lishengwen, xishengqi, wnaghong, wuyanrong. Sintering Properties and Microstructure of Fe-Ni-Co-based Superalloy Atomized Alloy Powder[J]. Rare Metal Materials and Engineering,2016,45(12):3115~3120.]
DOI:[doi]

Copy
Article Metrics
  • Abstract:
  • PDF:
  • HTML:
  • Cited by:
History
  • Received:September 01,2014
  • Revised:October 11,2014
  • Adopted:December 03,2014
  • Online: February 06,2017
  • Published: