+Advanced Search
The Influence of Carbon Nanotubes on Defects in AlSi10Mg alloy fabricated by Selective Laser Melting
Author:
Affiliation:

1.School of Materials Science and Engineering,Tsinghua University;2.Science and Technology on Plasma Dynamics Lab, Air Force Engineering University

Clc Number:

TG115.28

Fund Project:

  • Article
  • |
  • Figures
  • |
  • Metrics
  • |
  • Reference
  • |
  • Related
  • |
  • Cited by
  • |
  • Materials
  • |
  • Comments
    Abstract:

    Pure AlSi10Mg alloy and Carbon Nanotubes (CNTs)-AlSi10Mg composite with different CNTs addition were fabricated by selective laser melting (SLM). The CNTs-AlSi10Mg composite was strengthened when the CNTs content was lower than 0.05 wt.%. With the increasing CNTs content, however, the strength was decreased significantly because of the poor density. In order to understand the influence of CNTs on the defects in SLMed AlSi10Mg alloy, nano-CT technology was used to get the 3D information of the defects. The results indicated that the volume fraction of large defects(with diameter larger than 50 μm) in the total volume of defects was increased from 12% to 46% in CNTs(0.5wt.%)-AlSi10Mg composite. The number of gas pores in CNTs(0.5wt.%)-AlSi10Mg composite were significantly increased. The diameter of gas pores in CNTs(0.5wt.%)-AlSi10Mg composite were larger than that in pure AlSi10Mg alloy. The agglomeration of CNTs in the powder and gas adsorption are the fundamental reasons for the increase of the two types of defects.

    Reference
    Related
    Cited by
Get Citation

[Liu Xihe, Zhao Congcong, Zhou Xin, Liu Wei, Shen Zhijian, Florian Eibl, Wilhelm Meiners. The Influence of Carbon Nanotubes on Defects in AlSi10Mg alloy fabricated by Selective Laser Melting[J]. Rare Metal Materials and Engineering,2019,48(5):1637~1644.]
DOI:10.12442/j. issn.1002-185X.20180998

Copy
Article Metrics
  • Abstract:
  • PDF:
  • HTML:
  • Cited by:
History
  • Received:September 28,2018
  • Revised:October 22,2018
  • Adopted:November 08,2018
  • Online: June 04,2019
  • Published: